EA-Con-Clean
EA Con-Clean is a strong cleaner based on a proprietary organic acid blended with environmentally-safe surfactants. It is specially formulated to remove dirt and grime from concrete surfaces and is also a recommended step in preparing the surface to receive an Eco Advance sealer or water repellent. This non-toxic, non-flammable, non-caustic cleaner is safe to use on surfaces where water is safe to use. This product extends the life of coatings and sealers by aiding with adhesion and restores a cleaner, more natural look to your concrete surface.
Additional information
Product Use | Brick, Concrete, EIFS, Exterior Wood, Pavers, Stone |
---|---|
Finish/Sheen | Natural |
Recommended Surfaces | Horizontal, Vertical |
Application Method | Brush, Roller, Sprayer |
Details
Product Details
Product Use | Concrete |
Coverage | 150 to 200 sq ft per gallon |
Recommended Surfaces | Vertical, Horizontal |
Application Method | Sprayer |
pH | Typical 2.2 at 25 °C |
VOC Level | < 0 g/l |
Flammable | No |
Available Packaging | 1 Gallon, 5 Gallon, 30 Gallon, 50 Gallon, 275 Gallon |
How To Apply | Spray on and allow to dwell from 5 to 30 minutes. Scrubbing might be required for heavy soiling. |
Flash Point | No Data |
Specific Gravity | Typical 1.01 at 25 °C |
Vapor Density | No Data |
Biodegradable | Yes |
Location | Interior, Exterior |
Rinsing | Complete |
Appearance | Clear Liquid |
Foaming | Mild |
Odor |
Slight |
Wetting Ability | Excellent |
Stability | Good |
Directions
Application
Provide protection for foliage, pedestrian and vehicle traffic. Test all non-masonry surfaces for possible adverse reactions. Protect all surfaces and situations where damage may result from spillage or material drift.
All projects should start with a test application to determine cleaner suitability, dilution ratio and acceptable method for application. Test areas of at least 10 square feet are recommended and should involve the most severely contaminated area. Final determination of product acceptance should not be made until the test area has become dry.
EA-Con-Clean® is most effective when applied by low- pressure spray. Brush application and agitation may prove helpful on some surfaces. Dwell times are from 5 to 30 minutes. Do not let the cleaner dry on surfaces; mist with water or diluted cleaner to keep the surfaces wet. Removal of the cleaner and contaminant can be accomplished most successfully with pressure washing equipment. If only garden hose rinsing is available, light scrubbing or brooming during rinsing may be required. A thorough rinsing is required. Dilutions are 0 to 5 parts water. Projects where complete rinsing cannot be accomplished will require an additional neutralization step. Do not use on bright aluminum, metalized glass, “self cleaning” glass or fine wood surfaces.
Dilution
Dilution: 0 to 5 parts water to 1 part product — test application recommended.
Coverage
Approximately 150 to 200 square feet per gallon — dependent upon substrate and other conditions.